Displaying Configuration - GE MultiLink ML810 Instruction Manual

CHAPTER 5: IP ADDRESSING
5.4.3

Displaying configuration

MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
Using SWM, the need to display specific CLI commands for configuring capabilities is not
needed. The menus are modular and are alphabetically sorted to display each necessary
component in a logical manner. This section is repeated from the CLI manual, should the
need arise to view the necessary commands. The best way to view these commands is to
telnet to the switch using the Telnet menu from the Administration menu.
To display the configuration or to view specific modules configured, the 'show config'
command is used as described below.
Syntax show config [module=<module-name>]
Where module-name can be:
Name
system
event
port
bridge
stp
ps
mirror
sntp
llan
gvrp
snmp
web
tacacs
auth
igmp
smtp
If the module name is not specified the whole configuration is displayed.
ML810# show config
[HARDWARE]
type= ML810
slotB=8 Port TP Module
##########################################################
Areas affected
IP Configuration, Boot mode, Users settings (e.g. login
names, passwords)
Event Log and Alarm settings
Port settings, Broadcast Protection and QoS settings
Age time setting
STP, RSTP and LLL settings
Port Security settings
Port Mirror settings
SNTP settings
VLAN settings
GVRP settings
SNMP settings
Web and SSL/TLS settings
TACACS+ settings
802.1x Settings
IGMP Settings
SMTP settings
IP ADDRESSING
5–17