Xrj45 (Slot C); Fx St - 2 Km (Slot C) - GE MultiLink ML810 Instruction Manual

OPERATION
4.5.8 ML810 (C3), 2 x Multimode MTRJ / 2 x RJ45 (Slot C)
4.5.9 ML810 (EL), 2 x 10 FL + 2 x 100 FX ST - 2 KM (Slot C)
4–12
The ML810 (C3), 4-port Fiber / Copper module provides two 100Mb Multimode MTRJ Fiber
ports and two 10/100Mb switched RJ-45 ports.
The Multimode MTRJ ports support fiber optic cable distances up to the IEEE standard
100Mbps distance limits, typically 2km at full-duplex.
The ML810 (C3), copper ports support Ethernet twisted pair segments of any standard
length. It is equipped with a two-port RJ-45 connector, and offers 10/100 full / half-duplex
auto-negotiating capability on each port. The RJ-45 connector is shielded to minimize
emissions and will allow both unshielded twisted pair (UTP) and shielded twisted pair (STP)
cable connections. When installed in a Multilink ML810 Series Managed Switch, the copper
ports support the standard distance of 100m on each port.
(See Sections 5.1.2 and 5.1.7 for more details.)
4 x SC Multimode or 4 x ST Multimode
The ML810 (E3) (shown), 4-port Fiber module provides four 100Mb Multimode SC Fiber
ports. This option utilizes a SC-type "push-pull" fiber optic connection.
The ML810 (E1), 4-port Fiber module provides four 100Mb Multimode ST Fiber ports. This
option utilizes a ST-type "twist-lock" fiber optic connection.
The 100Mb Multimode SC and ST ports support fiber optic cable distances up to the IEEE
standard 100Mbps distance limits, typically 2km at full-duplex.
The ML810 (EM), 4-port Fiber module provides four 10Mb Multimode ST Fiber ports. This
option utilizes a ST-type "twist-lock" fiber optic connection. The 10Mb ST-fiber ports allow
the user to connect their legacy 10Mb network to the Multilink ML810 Series switch. It
supports distances according to the 10Base-FL standard (up to 2km for Multimode fiber)
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
CHAPTER 4: OPERATION