GE MultiLink ML810 Instruction Manual page 201

CHAPTER 13: RAPID SPANNING TREE PROTOCOL
Example 13-4: Configuring RSTP
rstp
ML810#
show stp config
ML810(rstp)##
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
RSTP/STP Enabled Ports
Protocol
Bridge ID
Bridge Priority
Bridge Forward Delay
Bridge Hello Time
Bridge Max Age
Root Port
Root Path Cost
Designated Root
Designated Root Priority
Root Bridge Forward Delay
Root Bridge Hello Time
Root Bridge Max Age
Topology Change count
Time Since topology Chg
show active-stp
ML810(rstp)##
Current Active Mode: RSTP.
RSTP is Disabled.
rstp enable
ML810(rstp)##
Successfully set the RSTP status
show active-stp
ML810(rstp)##
Current Active Mode: RSTP.
RSTP is Enabled.
show stp config
ML810(rstp)##
RSTP CONFIGURATION
-----------------
MULTILINK ML810 MANAGED EDGE SWITCH – INSTRUCTION MANUAL
: 1,2,3,4,5,6,7
: Normal RSTP
: 80:00:00:20:06:2b:e1:55
: 32768
: 15
: 02
: 20
: 0
: 0
: 80:00:00:20:06:2b:e1:55
: 32768
: 15
: 02
: 20
: 0
: 935
RAPID SPANNING TREE PROTOCOL
Check the status of STP or RSTP. These
commands show if STP or RSTP is
enabled.
13–9