Stopping A Triggered Pre-Alarm - Aastra A150 User Manual

Alarm
■ Response times
You can set the following response times (hh:mm:ss):
• Detection duration
• Sensitivity
• Alarm cancellation delay
• Alarm confirmation time
As soon as the phone detects an alarm situation, the
only triggered when the detection duration has completely expired and the alarm status has
constantly occurred during this time. You can set a different duration for each alarm:
• The detection duration for man-down and no-movement alarm: min. 00:00:10 up to
max. 23:59:59.
• The detection duration for escape alarm: min. 00:00:05 up to max. 00:00:59.
For no-movement and escape alarm you can also set the Sensitivity (High, Medium, Low) of the
detection.
The Alarm cancellation delay
ger. You set the duration for all alarms together: min. 00:00:00 up to max. 00:59:59.
The Alarm confirmation time
acknowledged on the phone. You set the duration for all alarms together: min. 00:00:00 up to
max. 23:59:59.
If the alarm settings are protected by the Admin PIN (see chapter
page 83) you will be prompted for it before you can make the first change. After you have
entered the correct Admin PIN, all the alarm settings are freely accessible until you return to the
idle state.

■ Stopping a triggered pre-alarm

The man-down, no-movement and escape alarm has been triggered and you now want to stop
it.
You can stop the alarm on the phone as long as no alarm message has been sent to the alarm
system. Whether you can still stop the alarm thereafter depends on the alarming concept set.
Cancel
78
indicates the pre-alarm's duration as of when the alarm is to trig-
indicates how long the alarm shall ring as long as the receipt is not
No-movement, man-down and escape alarm was triggered:
Press the Cancel softkey or any key.
➔
The pre-alarm on the phone is stopped.
Detection duration starts to run. An alarm is
"Locking the alarm settings",
Aastra 630d