Reset To Factory Default Settings; Upgrading System Firmware - Thecus N4100+ User Manual

Module Management
Item
Module File
Browse
Install
Name
Version
Description
Enable
Uninstall
Enable
Disable
NOTE

Reset to Factory Default Settings

From the System menu, choose the
Factory Default item and the Reset to
Factory Default screen appears. Press
Apply to reset the N4100+ to factory
default settings. Press Cancel to go back to
the main menu.
WARNING

Upgrading System Firmware

From the System menu, choose the
Firmware Upgrade item and the
Firmware Upgrade screen appears.
Follow the steps below to upgrade your
firmware:
1. Use the Browse button to find the
firmware file.
2. Press Apply.
3. The beeper beeps and the Busy LED
blinks until the upgrade is complete.
NOTE
Description
Location of the module file.
Click to browse the folder of your PC to locate the module files.
Click to install the listed module into your N4100+.
Displays the name of the module.
Displays the module version.
The description of the module.
Displays whether the module has been enabled or not.
Click to uninstall the module.
Click to enable a module.
Click to disable a module.
Modules can potentially harm your system. Only install modules from your vendor,
or publishers you can trust.
Resetting to factory defaults will not erase the data stored in the hard disks, but
WILL revert all the settings to the factory default values.
• The beeper only beeps if it is enabled in the System Notification menu.
• Check Thecus website for the latest firmware release and release notes.
41