Checking System Status; System Status Ok; System Trouble; Installation Wizard - Thecus N4100+ User Manual

Checking System Status

System Status OK

The system status is OK if:
1. The front panel Power LED glows blue and the WAN LED glows or blinks
green.
2. The HDD Power LED on each HDD tray glows blue.

System Trouble

The system has trouble if:
1. Any LED glows red.
2. The system emits a continuous beeping sound.
If the system has trouble, refer to

Installation Wizard

The handy Thecus Setup Wizard makes configuring N4100+ a snap. To configure
the N4100+ using the Setup Wizard, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
NOTE
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to
Chapter 7: Troubleshooting
You must have administrator privileges to correctly install the N4100+ with the
installation wizard. Please make sure that you are logged in as the administrator, or
have administrator privileges.
For MAC OS X users, double click on Thecus Setup Wizard 1.1.6.dmg
Chapter 7: Troubleshooting for assistance.
13
Guide.