Set Up Device Id Number - Planet CAM-ISD52 User Manual

To build correct network for control communication, every speed dome camera in
the network must have an unique ID number, which is set by the bit 1 to 10 of a
DIP switch DS1(bit1-8) & DS2(bit 1~2).
Factory default of device ID is 1
Note:
remark: D
ash line "---" in tables means to set the bit to "OFF" position
Find DIP switch DS1 & DS2 on the PC board
DS1
Complete ID setting involves the whole DS1 (as 1-8) and the two left
pins of DS2 (as 9 and 10) (see picture on above)
Refer to the tables in the following pages for ID setting (which shows
the assignment of each pin for different ID numbered from 1 to 1024)
The highest ID number of this camera is 1024.
All the speed domes in a network must have their unique ID. It is highly
recommended to installers, for future maintenance efficiency and
users' convenience, to mark the ID of each camera onto its
corresponding location on the site map, and make out a list of cameras
with their ID numbers.
The DIP switch pin assignment for ID setup is in binary format.
.
User's manual

4.2 Set Up Device ID Number

ID setting group ( of 10 pins)
Bit 1~8
&
9 10
DS2
.
9