Play Tone; Play All; Response - Minelab CTX3030 Instruction Manual

NOTE
Tones can only be played through
the detector speaker, not through
the WM 10.
CTX 3030 Instruction Manual
Modes Menu
4. Use the left and right arrow buttons to move the cursor to each number in turn;
increase or decrease each number using the up and down arrows.
5. When editing is complete, press Select.
6. The Tone ID Profile will be displayed with your updated pitch.
7. Press Select to return to the Tone ID Profile.
8. Repeat steps 1 to 7 for each section you want to edit.
Figure 28 – Change Pitch

Play Tone

The Play Tone option allows you to listen to one selected tone in your Tone ID
Profile.
1. From the Tone ID Profile menu, highlight the Play Tone option and press Select.
The currently selected tone will sound.

Play All

The Play All option allows you to listen to all tones in your current Tone ID Profile.
1. From the Tone ID Profile menu, highlight the Play All option and press Select.
The current Tone ID Profile will be displayed and each tone will sound.

Response

Range: Normal, Long, Smooth and Pitch Hold
The Response setting changes the way target signals sound upon detection.
Response can improve your ability to identify certain targets in different conditions,
such as high trash, mineralized ground and beaches.
As the coil is swept over a target, the target signal rises. At the peak of the target
signal, audio is emitted. Minelab recommends initially learning how to operate the
detector in the Factory Preset 'Normal' audio Response.
The Response options are:
• Normal
• Long
• Smooth
• Pitch Hold
38