Battery Care And Safety - Minelab CTX3030 Instruction Manual

WARNING
Please note the following:
CTX 3030 Instruction Manual
Batteries

Battery Care and Safety

To extend battery life:
• Use headphones; the speaker uses more power than headphones
• Turn off the backlight; the backlight increases the power consumption by
approximately 8%
• Turn the detector off when not in use
• Turn GPS off when not in use
• Turn Wireless off when not in use
The Lithium-Ion battery is specifically designed for the CTX 3030. Attempting to use the
Lithium-Ion battery pack with other detectors may damage the detector or the battery pack.
VERY IMPORTANT: Ensure the battery seal (o-ring), the o-ring seating groove and the mating
face of the battery are undamaged and kept clean of sand, grit and other contaminants.
Securely connect the battery to the detector before submersing in water.
Do not try to adapt this battery to other models as it will very likely cause damage.
Do not charge the battery at temperatures above 113° F (45° C) or below 32° F (0° C).
Do not immerse the battery pack in any liquid or allow water ingress. Battery packs are not
waterproof until connected to the detector.
Ensure both the battery pack and control box are completely dry before connection.
Remove the battery pack from the detector during air travel or long term storage.
Do not immerse the BC 10 charger in any liquid or allow water ingress.
Do not leave the battery in hot conditions (e.g. on the dashboard or rear parcel shelf of your
car).
Do not damage the battery in any way.
Do not short-circuit the battery.
Do not use the battery if it is damaged or deformed.
Do not disassemble or reconstruct the battery.
Do not incinerate the battery.
In the event of a fault, return the battery to a Minelab authorised service centre for
repair. The use of unapproved components will VOID YOUR WARRANTY. There are no user
serviceable parts within this battery pack.
59