Minelab CTX3030 Instruction Manual page 2

CTX 3030 Instruction Manual
WARNING
THIS DOCUMENT CONTAINS INTELLECTUAL PROPERTY, TECHNICAL AND PROPRIETARY DATA AND INFORMATION AND OTHER MATERIAL
OWNED SOLELY BY MINELAB ELECTRONICS PTY LIMITED.
THIS MATERIAL MUST NOT BE USED WITHOUT THE PRIOR WRITTEN PERMISSION OF MINELAB ELECTRONICS PTY LTD.
© MINELAB ELECTRONICS PTY LTD. ALL RIGHTS RESERVED
This document is protected by copyright. Apart from any use permitted under the Australian Copyright Act 1968 (Cth) or other
applicable laws, any unauthorised use, appropriation or reproduction of this document or any part of it is strictly prohibited. No part of
this document may be used or reproduced by any means or by any process, in any form, without the prior written permission of the
copyright owner Minelab Electronics Pty Ltd of 118 Hayward Avenue, Torrensville, SA 5031, Australia.
COMPLIANCE
Information to the User (FCC Part 15.105)
NOTE: Class B Devices
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
DISCLAIMER
The Minelab metal detector discussed in this instruction
manual has been expressly designed and manufactured as a
quality hobbyist metal detector and is recommended for use
in coin, treasure and general metal detection in nonhazardous
environments. This metal detector has not been designed for use
as a mine detector or as a live munitions detection tool.
Minelab®, CTX®, Smartfind™ 2, FBS 2®, Wi-Stream™, GPSi™, FindPoint®, GeoHunt™, GeoTrail™, XChange Your Detecting Connection™, Target
Trace™, Ferrous-Coin Separation™, Ground-Coin Separation™ are trademarks of Minelab Electronics Pty. Ltd. Google Maps is a trademark of
Google Inc. u-blox is a trademark of u-blox Holding AG.
PLEASE NOTE
Since there may be a variety of options available for this
detector, equipment may vary according to the Model or items
ordered with your detector. Certain descriptions and illustrations
may also differ (in this manual) from the exact Model that you
purchased. In addition, Minelab reserves the right to respond to
ongoing technical progress by introducing changes in design,
equipment and technical features at any time.
ii