Straight-Through Twisted-Pair Cable For 10 Mbps Or 100 Mbps Network Connections; Cable Diagram; Pin Assignments - HP ProCurve Series 2600 Installation And Getting Started Manual

Straight-through Twisted-Pair Cable for
10 Mbps or 100 Mbps Network Connections
Because of the HP Auto-MDIX operation of the 10/100 ports on the switch, for
all network connections, to PCs, servers or other end nodes, or to hubs or
other switches, you can use straight-through cables.
If any of these ports are given a fixed configuration, for example 100 Mbps/
Full Duplex, the ports operate as MDI-X ports, and straight-through cables
must be then used for connections to PC NICs and other MDI ports.

Cable Diagram

N o t e
Pins 1 and 2 on connector "A" must be wired as a twisted pair to pins 1 and 2
on connector "B".
Pins 3 and 6 on connector "A" must be wired as a twisted pair to pins 3 and 6
on connector "B".
Pins 4, 5, 7, and 8 are not used in this application, although they may be wired
in the cable.
.

Pin Assignments

Switch End (MDI-X)
Signal Pins
receive + 1
receive - 2
transmit + 3
transmit - 6
Switch Ports and Network Cables
Twisted-Pair Cable/Connector Pin-Outs
Computer, Transceiver, or
Other End
Pins Signal
1 transmit +
2 transmit ­
3 receive +
6 receive ­
B-7