Installing Or Removing Mini-Gbics - HP ProCurve Series 2600 Installation And Getting Started Manual

2. Installing or Removing mini-GBICs

You can install or remove a mini-GBIC from a mini-GBIC slot without having
to power off the switch. Use only ProCurve mini-GBICs.
N o t e s
When this manual was printed, the supported mini-GBICs include the
following:
C a u t i o n
Use only supported genuine ProCurve mini-GBICs with your switch. Non-
ProCurve mini-GBICs are not supported, and their use may result in product
malfunction. Should you require additional ProCurve mini-GBICs, contact
your ProCurve Networking Sales and Service Office or authorized dealer.
Installing the mini-GBICs:
Remove the protective plastic cover and retain it for later use. Hold the mini-
GBIC by its sides and gently insert it into either of the slots on the switch until
the mini-GBIC clicks into place.
W A R N I N G
The ProCurve mini-GBICs are Class 1 laser devices. Avoid direct eye
exposure to the beam coming from the transmit port.
The mini-GBIC slots are shared with the two 10/100/1000Base-T RJ-45
ports. If a mini-GBIC is installed in a slot, the associated RJ-45 port is
disabled and cannot be used.
The mini-GBIC ports operate only at full duplex. Half duplex operation is
not supported.
Ensure the network cable is NOT connected when you install or remove
a mini-GBIC.
ProCurve Gigabit-SX-LC mini-GBIC (J4858A and J4858B)
ProCurve Gigabit-LX-LC mini-GBIC (J4859A and J4859B)
ProCurve Gigabit-LH-LC mini-GBIC (J4860A and J4860B)
4 3
4 2
4 1
4 0
3 9
3 8
3 7
-T
G ig
r ts
P o
M
4 8 5 0 i-
M in
4 7
T G B IC
4 7
r ts
M P o
4 6
4 9
o r t
4 5
T it p
4 4 a b
G ig
c h
e a
fo r
M )
o r
e (T
o n
n ly
e o
U s
!
4 8
Installing the Switch
Installation Procedures
2-7