Direct Console Access - HP ProCurve Series 2600 Installation And Getting Started Manual

Direct Console Access

To connect a console to the
switch, follow these steps:
1. Connect the PC or
terminal to the switch's
Console Port using the
console cable included
with the switch. (If your
PC or terminal has a 25-pin
serial connector, first
attach a 9-pin to 25-pin
straight-through adapter
at one end of the console
cable.)
2. Turn on the terminal or
PC's power and, if using a
PC, start the PC terminal
program.
3. Press two or three times and you will see the copyright page and
[Enter]
the message "Press any key to continue". Press a key, and you will then
see the switch console command (CLI) prompt, for example:
ProCurve Switch #
If you want to continue with console management of the switch at this time,
see chapter 3, "Getting Started With Switch Configuration" for some basic
configuration steps. For more detailed information, refer to the Management
and Configuration Guide, which is on the Documentation CD-ROM that came
with your switch.
Installation Procedures
Console port
Console cable supp lied
with the switch
PC running a terminal
emulator program, or
a VT-100 terminal
Installing the Switch
Conso le
2-31