Led Behavior - HP ProCurve Series 2600 Installation And Getting Started Manual

Installing the Switch
Installation Procedures
2. Check the LEDs on the switch as described below.
When the switch is powered on, it performs its diagnostic self test. Self test
takes approximately 50 seconds to complete.

LED Behavior

2-10
Self Test LED
Power and
Fault LEDs
1 3
hp procurve
swit ch 2 4
2650-PWR
1
J8165A
PoE
Status
RPS Act
LED
EPS FDx
Mode
Power
Fan Spd
Test
PoE
Fault
2
Reset Clear Spd mode: off = 10 Mbps,
Test LED
During the self test:
• Initially, all the switch and port LEDs are on. Most of the LEDs go off
and then may come on again during phases of the self test.
• For the duration of the self test, the Self Test LED stays on.
Switch port LEDs
5 7 9 11 13
6 8 10 12 14
11 13
12 14
flash = 100 Mbps, on = 1000 Mbps
Switch 2650
Switch 2650-PWR
15 17 19 21 23 Link| M
16 18 20 22 24
23
24
PoE-Ready 10/100Base-TX Ports (1 - 48 )