600 Rps/Eps Leds - HP ProCurve Series 2600 Installation And Getting Started Manual

600 RPS/EPS LEDs

The 600 RPS/EPS LEDs are located on the back of the device. These LEDs are
duplicated on the front of the device for your convenience. The following
graphic shows an example of the back of the 600 EPS/RPS. There are two
green LEDs for each RPS and EPS port:
RPS Device Connected LED
R PS Power: 12V backup to one connected device. Lowest-numbered port has prior y it .
R3
RPS 3 RPS 4
The following states provide status of the RPS and EPS ports.
Fault (located on Device
the front)
Off
On or Off
Off
Off
Blinking
Off
Device Connected
Power Status
RPS Power Status LED
R4 R5
RPS 5 RPS 6
Connected
Off
Off
On
On
Off
On
EPS Device Connected LED
! EPS Power: 50V 370W total for PoE applications. Power is shar
R6 E1
EPS 1 EPS 2
Power Message
Status
Off Nothing Connected
On Not a valid state - should never happen
Off Switch is connected, RPS is available but
not required
On RPS is powering the connected device
Blinking RPS/EPS port is in fault condition
Blinking Switch is requesting power, RPS can not
provide it. (N/A for EPS)
Installing the Switch
Installation Procedures
EPS Power Status LED
ed w hen both ports are used.
Device
E2
Connected
Power
Status
Li ne: 50/60 Hz.
10 0 - 240 V~ 9.1A (9,1A )
2-23