Operating Your Appliance; Location And Use Of Controls - Travis Industries Flex-95 Owner's Manual

OPERATING YOUR APPLIANCE

Location and Use of Controls

NOTE: The Bypass Damper Control becomes hot during operation. Use the included adjustment
tool to adjust this control while the appliance is hot.
Combustion Air Control
The Combustion Air Control is located in the center under the door and is operated by pushing or pulling
the control. When the control is pulled out, it is in the fully closed position. When it is pushed in, it is in the
fully open position.
Bypass Damper Control
The Bypass Damper Control is located above the door in the center, and is operated by pushing or pulling
the control. When pulled out all the way, the bypass damper is open, causing the catalytic combustor to
be bypassed. When it is pushed in, the flue gases are channeled through the catalytic combustor.
Catalytic Combustor Gage
The Catalytic Combustor Temperature Gage is used to measure the temperature inside the catalytic
combustor. This temperature is used determine when to bypass the catalytic combustor and if it is
working correctly.
Bypass Damper Control (Becomes Hot During Use)
Out = Catalytic Combustor Bypassed
In = Flue Gases Channeled Through Catalytic Combustor
Combustion Air Control
In = Open
Out = Closed
Catalytic Combustor
Temperature Gage
(Measures the
temperature inside the
Catalytic Combustor)
Page 41