Travis Industries Flex-95 Owner's Manual page 29

INSERT OPTIONAL EQUIPMENT (Continued)
4. Bay Kit (Continued)
3. Un-screw the handle on the damper rod before installing the bay kit top panel. Slide the top panel
onto the top of the side bays. The top panel has joggle clips that hold the top panel in place against
the insert and the side bays. The best way to insert the top panel is to hold it at an angle and insert
one side first and gradually lower it until the opposite side is inserted. Adjust the top panel so its
edges are flush with the side edges of the side panels. Replace the damper rod handle after the top
panel is in place.
4. Adjust the position of the side bays so they are: 1) flush with the bottom of the insert; 2) both the same
distance back from the front of the insert; 3) perpendicular to the floor. Tighten once the side bay is
properly aligned.
NOTE: If using a positive or direct connection, the top panel should be installed after the
flue is connected to the appliance.
5. The brass trim is pre-assembled and can be slid over the top panel of the bay kit.
6. Blower, Front
The front blower is designed to improve the natural convection of the stove by pushing air through the
convection chamber of the stove and causing the heated air to exit through the vents along the top of the
stove. It also has a thermodisk which turns the blower on and off automatically. Refer to the illustration on
the following page while following the directions to attach the blower.
1. Remove the two screws below the ashlip with a 3/8" nutdriver.
2. Place the blower under the ashlip and align the two slots in the back mounting bar with the two holes
in the face of the appliance.
3. Insert one of the screws in each hole. Pull the blower assembly up as far as it will go to eliminate any
space between the blower and ashlip.
Place the top panel for the bay
kit over the insert. There are four
joggle clips on the top panel
that slide over the side bays
and top flange that hold the top
panel in place.
The brass trim fits over the top
portion of the top panel.
Un-screw the damper
control handle before
installing the top panel
of the bay kit. Re-install
the handle after the top
panel is in place
Page 29