Freestanding Optional Equipment - Travis Industries Flex-95 Owner's Manual

FREESTANDING OPTIONAL EQUIPMENT

Your Lopi Flex-95 appliance comes completely assembled. The optional items available for the
freestanding method of installation are listed below and require assembly. THE TOP KIT IS
MANDATORY FOR FREESTANDING INSTALLATIONS.
1. Top Kit (Includes the top panel and a flue extender)
2. Pedestal
3. Leg Kit, Steel
4. Leg Kit, Brass
5. Leg Kit, Cast
6. Blower, Front
7. Outside Air (Available with Pedestal or Outside Air Boot and Legs)
1. Top Kit
The top kit is mandatory for freestanding installations and contains both a top panel and flue extender.
The directions below detail the installation of this kit.
1. Unscrew the damper rod where it connects near the flue and
remove it from the stove (see the illustration to the right).
Next, remove the damper rod guide located in the center of
the damper rod by unscrewing the two screws that hold it in
place with a 5/16" nutdriver.
2. Included with the flue extender is a roll of self-adhesive glass
tape. Attach this tape along the top of the stove around the
perimeter of the flue (see the illustration below). This tape
acts as a gasket between the flue extender and the stove.
3. Place the flue extender over the flue so it is centered over the
opening and the hole for the bypass damper rod is facing
forwards. The flue extender is held in place with three bolts
and tabs that attach to a threaded shaft on the inside the flue
extender. With the flue extender centered over the flue,
place a bolt with a tab inserted over it, into the threaded shaft
from below so the tab extends outwards from the flue
opening (see
the illustration below). Tighten the bolt until the tab contacts the stove. Do not fully
tighten this bolt at this point. Repeat for the remaining two bolts and tabs.
Place the
glass tape
on top of
the stove
around the
perimeter
of the flue.
Top of Stove
4. Re-attach the damper rod that was removed in step one by inserting it through the hole in the front
and flue extender and screwing it into the rod it was removed from.
5. Attach the top panel to the stove by placing it over the flue extender and carefully pushing it down until
it is secure. See the above right illustration. Before tightening the bolts that hold the flue extender in
place, make sure the flue extender is aligned properly and that the damper bypass goes in and out
freely.
Threaded shaft on
the flue extender.
Flue extender
The bolt
goes
through the
threaded
shaft from
Inside of flue
the bottom.
Page 8
Remove the Unscrew the
damper rod damper rod
guide with here.
a 5/16"
nutdriver.