Travis Industries Flex-95 Owner's Manual page 60

REPLACEMENT PARTS AND REMOVAL INSTRUCTIONS
(Continued)
Removing and Replacing the Firebricks (Continued)
REMOVING THE SIDE FIREBRICKS
1. Follow the directions for removing
the back and floor firebricks.
2. Once the floor firebricks are
removed, the side firebricks can be
pivoted out from behind the metal
clips that hold the firebricks in
place. Grasp the bricks, one at a
time, from the bottom and pivot
them out from the bottom. See the
diagram to the right to see the
order of removal.
3. To replace the side and back
firebricks, follow these directions in
reverse order, placing the bricks
snug against each other and
against the walls of the firebox.
REMOVING THE BAFFLE (TOP) FIREBRICKS & COMPONENTS
1. Make sure the appliance
is cool and cleaned out.
2. Remove the door by
opening it and pulling it
upwards. Make sure to
grasp the door by both
ends. It is heavy and can
be damaged.
3. The illustration to the right
shows the order of
removal for the baffle
firebricks. The rear three
bricks can be removed by
sliding them to either
side, rotating the back
end down, then twisting
them so they are on end
and then feeding them
out (see the illustration on
the following page).
8
7
6
5
3
6
5
Cut Firebrick -
4 7/8" by 4 1/2"
with a 1 1/4"
thickness
Front
Baffle
Support
Page 60
Metal clips that hold
the side firebricks in
place.
4
3
2
1
Ledge at
rear of
firebox
2
1
4
Rear
Baffle
Support