Travis Industries Flex-95 Owner's Manual page 9

FREESTANDING OPTIONAL EQUIPMENT (Continued)
2. Pedestal Assembly:
Open the box marked Pedestal and
remove the pedestal and the two
attachment bolts and washers (3/8"
diameter - 16 x 3/4" hex. head bolts).
Included with the pedestal kit is a
rodent screen and a roll of insulation.
These items are used for an outside air
connection. Refer to the isntructions
included with the kit if installing the
outside air option.
Lift the stove onto the pedestal. Line up the threaded bolt holes in the bottom of the stove with the two
holes in the tabs that stick out of the side of the pedestal. Using an open-end or socket wrench, fasten the
pedestal to the stove with the supplied bolts and washers.
3. Steel Leg Kit Assembly:
Open the box marked Steel Leg Kit and remove the four 6 1/2" high black steel legs, complete with
rubber-tipped leveling bolts, the four attachment bolts (3/8" diameter - 16 x 3/4" hex. head bolts) and the
washers.
Raise the stove on some pieces of lumber to a height of about 7". Line up the hole in the top of the leg
with the threaded bolt hole in each corner of the stove bottom. Using a 9/16" open end or socket wrench,
fasten the leg to the stove with the supplied attachment bolts and washers, making sure the legs are flush
with the corners of the stove.
To level the stove, first make sure the leveling bolts with the rubber ends (some models come with steel
bolts -- the same directions apply) are screwed into position and backed off just enough to penetrate
below the steel portion of the leg. Unscrew each leveling bolt just enough so each leveling bolt is an
equal distance from the floor. You may wish to use a piece of wood or other spacer to measure this
distance. Next, lower the stove onto the ground and check for a level position. If slight adjustments need
to be made, make sure to first raise the stove before turning the leveling bolts or moving the stove. The
rubber tips of the leveling bolts will tear if they are adjusted or slid while weight is applied to them.
4. & 5. Brass and Cast Legs Assembly:
Open the box marked Brass (or Cast) Leg Kit and remove the four 7 7/8" high legs, complete with rubber-
tipped leveling bolts, the four attachment bolts (3/8" diameter - 16 x 3/4" hex. head bolts) and the washers.
Use the same directions listed above for the steel legs
assembly. The one difference is that the brass (or cast) legs
are taller, and the stove should be lifted approximately 8 1/2"
above the floor before attachment.
Attach the pedestal
to the stove here
Attach Bolt (with
washer) to Stove
From Below
Page 9
Optional Air Intake Port
Attach Bolt (with
washer) to Stove
From Below