Operating Your Heater; Before You Begin; Location Of Controls - Travis Industries heritage bay Owner's Manual

Before You Begin

! Read this entire manual before you use your new heater (especially the section "Safety
Precautions" on pages 2 & 3). Failure to follow the instructions may result in property
damage, bodily injury, or even death.
Location of Controls - See explanation below
PILOT
IGNITER
Pilot Igniter
On/Off Switch
Gas Control Knob
Flame Adjust Knob
Pilot Igniter
Blower Knob
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the heater off always.
The on/off switch is
located on the
back of the heater.
Swing the control cover
down to access the gas
control valve, igniter, and
blower control.
OFF
HI
LO
Blower Knob
This control is used to turn the main burner on and off.
This knob is used to control gas to the heater and for starting the pilot. There
are three positions, ON, OFF, & PILOT. The pointer directly below the knob
indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer to the upper left of the knob points to the position this knob is in.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
This knob controls the speed of the internal convection blower that pushes the
heated air into the room.
O
PERATING
ON/OFF
Switch
PILOT ADJ
Gas Control
Knob
Y H
OUR EATER
The Pilot Flame
can be found below
the back log.
Gas Control Valve
Flame Adjust
Knob
P 19
AGE