Memory Problems - HP ProLiant DL100 Series User Manual

Server response time is slower than usual
Action: Be sure the hard drive is not full, and increase the amount of free space on the hard drive, if
needed. It is recommended that hard drives should have a minimum of 15 percent free space.
No hard drives are recognized
Action: Be sure no power problems (on page 68) exist.
A new hard drive is not recognized
Action:
Be sure the drive is supported. To determine drive support, see the server documentation or the HP
1.
website (http://www.docs.hp.com).
Be sure the drive bay is not defective by installing the hard drive in another bay.
2.
Run HP Insight Diagnostics (on page 51). Then, replace failed components as indicated.
3.
When the drive is a replacement drive on an array controller, be sure that the drive is the same type
4.
and of the same or larger capacity than the original drive.

Memory problems

General memory problems are occurring
Action:
•
Isolate and minimize the memory configuration. Use care when handling DIMMs
guidelines" on page 55).
Be sure the memory meets the server requirements and is installed as required by the server.
o
Some servers may require that memory banks be populated fully or that all memory within a
memory bank must be the same size, type, and speed. To determine if the memory is installed
properly, see the server documentation.
Check any server LEDs that correspond to memory slots.
o
If you are unsure which DIMM has failed, test each bank of DIMMs by removing all other
o
DIMMs. Then, isolate the failed DIMM by switching each DIMM in a bank with a known working
DIMM.
Remove any third-party memory.
o
•
To test the memory, run HP Insight Diagnostics (on page 51).
Server is out of memory
Action:
Be sure the memory is configured properly. Refer to the application documentation to determine the
1.
memory configuration requirements.
Be sure no operating system errors are indicated.
2.
Be sure a memory count error
3.
message displaying memory count during POST.
("Memory count error exists" on page 78) did not occur. Refer to the
("DIMM handling
Troubleshooting 77