Gps Receiver Specifications - Primex 14000 Series Installation & User Manual

System Specifications
Figure 3: 14000 Series Transmitter Display
Display Specifications
Table 1: 14000 Transmitter Display Specifications
Component
Time
Daylight Saving Time
GPS Communication
Day/Date
Channel Number
Red LED

GPS Receiver Specifications

The GPS receiver draws time information from the U.S. Government Satellites, providing the system with Coordinated Universal Time
(UTC).
Mounted to rooftop, pole, or window (not a Low-E glass window).
l
GPS receiver sends the UTC time to the transmitter via the NMEA 0183 standard protocol.
l
Primex Wireless
Description
Displays the precise time received from the GPS Receiver.
If AM or PM is on the display, then the 12-hour option is selected.
If neither AM nor PM is on the display, then the 24-hour option is selected.
The letters "DT" (Daylight Saving Time) or "ST" (Standard Time) will be displayed
when adjustment for Daylight Saving Time is active.
If neither "DT" nor "ST" is displayed, then switch #3 is in the down position and the
transmitter will not adjust for Daylight Saving Time.
The GPS Communication indicator
communicating with the GPS Receiver.
The parentheses indicate the time signal is being received.
Displays the day and date received from the GPS satellite.
Displays the channel number (1-16) the transmitter is set to.
The red LED (Light Emitting Diode) is located on the right side of the front panel of
the transmitter.
The LED flashes on initial setup until a GPS time signal is received or when a
severe GPS Receiver signal problem has occurred and no time data has been
received from the GPS Receiver in 48 hours.
See the Troubleshooting section of this guide for additional information.
14000 Series Transmitter - External Antenna Installation & User Guide
appears when the transmitter is
GPS Receiver Specifications
5