Primex 14000 Series Installation & User Manual page 17

Installation and Configuration
Install Pole Mount Kit
The Pole Mount kit is designed for the purpose of mounting the ground plane ominidirectional antenna to round or angled tower legs.
The clamps can be used on round tower legs that measure for 1.25" to 3.25" (3.17cm to 8.25cm) OD or on angled tower legs that
measure up to 3" (7.62cm) on a side.
The center section of each clamp is welded to proved mechanical stability and all parts are hot-depped galvanized steel.
Kit Contents
The kit is supplied with the following parts. If any of these items are missing, please contact Primex Wireless.
Description
5' by 1.25" rigid galvanized conduit section
5' by 1" rigid galvanized conduit section
X style clamp
U-clamp
1/2" all thread bolt
1/2" lock washer
1/2" hex nut
Mounting Antenna Using Pole Mount Antenna Kit
Complete the steps below to mount the antenna using the pole mount antenna kit.
1. Verify the kit contents.
2. Assemble both clamps, as shown in Figure 8, tightening the hex nuts to an approximate torque of approximately 45 ft-lbs.
3. Tighten half of one clamp two feet below the top of the pole. Use a 3/4" wrench to do this and be sure to tighten the clamps both
evenly and securely.
4. Tighten half of the other clamp, using a 3/4" wrench, a few inches below the top of the pole. Be sure to tighten the clamps both
evenly and securely.
5. Connect the LMR 400 cable to the antenna. Be sure the connection is tight.
6. Insert the mast into the clamps. The bottom of the mast should be a minimum of 2" below the bottom clamp.
7. Tighten all nuts on both clamps using a 3/4" wrench. The final assembly is to resemble Figure 8.
8. Next, route the antenna cable. For additional information, see "Route Antenna LMR 400 Coaxial Cable" located on page 14.
Primex Wireless
14000 Series Transmitter - External Antenna Installation & User Guide
Mount the Antenna Mast
Qty
1
1
2
4
4
16
16
13