Table of Contents
Advertisement
Installation and Configuration
Assemble Ground Plane Omnidirectional Antenna
Complete the steps below to assemble the antenna.
1. After removing the antenna from the shipping box, inspect all contents to ensure all parts are on hand and no damaged has
occurred during shipping.
2. Screw the radials (3) into the base of the antenna.
3. Assemble the U-bolt on the base of the antenna. The Mast is to be aligned with the top of the mast channel.
Figure 4: Antenna Assembly
Assemble Antenna Mast
The Antenna Mast has two sections secured by a hex bolt during shipment. The two sections include a 5' by 1.25" (1.52m by 2.54cm)
rigid galvanized conduit and a 5' by 1" (1.52m by 3.17cm) rigid galvanized conduit.
NOTE:
The Non-penetrating mounting kit only includes the 5' by 1.25" rigid galvanized conduit section.
Complete the steps below to assemble the antenna mast.
1. Loosen and remove the hex bolt.
2. Remove the 5' by 1" rigid galvanized conduit section.
3. Insert the 5' by 1" rigid galvanized conduit section into the 5' by 1.25" rigid galvanized conduit section in reverse as shipped to
attain a combined antenna mast length of 9' (2.74m).
4. Align the sections' fastening holes and secure sections together using the supplied hex bolt and nuts.
Mount the Antenna Mast
NOTE:
Mounting the antenna mast may require two people.
Primex Wireless
14000 Series Transmitter - External Antenna Installation & User Guide
Assemble Ground Plane Omnidirectional Antenna
9
Hide quick links:
Advertisement
Table of Contents
