Secure Antenna To Mast; Connect Cables - Primex 14000 Series Installation & User Manual

Installation and Configuration
1. Verify the kit contents.
2. Verify the installation location meets the installation guidelines.
3. Assemble and mount the GPS receiver unit to an inside of a window (not Low-E glass), an outside pole, or rooftop. The mounting
location is required to have a clear view of the sky.
CAUTION:
Figure 9: GPS Receiver Installation Components and Illustration

Secure Antenna to Mast

Complete the steps below to secure the antenna to the mast.
1. Attach and fasten the antenna channel side base to the top of the 1" rigid galvanized conduit section.
2. Use a 1/2" wrench to tighten the nuts on both of the U-bolts, both evenly and securely. Tighten the second nut to the first nut, to
ensure it is secure.

Connect Cables

Complete the steps below to connect the GPS and LMR 400 cable to the transmitter.
1. Connect the GPS cable to transmitter "GPS IN" port, located on the rear of the transmitter.
2. Connect the LMR 400 cable to the transmitter "External Antenna" port, located on the rear of the transmitter.
Primex Wireless
Be sure to follow local building code requirements when attaching the GPS unit to the inside of a window.
Clean the windowpane before using the suction cups for attachment.
14000 Series Transmitter - External Antenna Installation & User Guide
Secure Antenna to Mast
15