Primex 14000 Series Installation & User Manual page 14

Installation and Configuration
There are three available mounting methods. The method used is dependent upon the mounting kit supplied with the system.
Non-Penetrating Antenna Kit: See "Install Non-Penetrating Antenna Kit" for detailed mounting instructions.
l
Penetrating Antenna Kit: See "Install Penetrating Antenna Kit" for detailed mounting instructions.
l
Antenna Pole Mounting Kit: See "Install Pole Mount Kit" for detailed mounting instructions.
l
Install Non-Penetrating Antenna Kit
The Non-Penetrating Antenna Kit is designed for mounting a ground plane omnidirectional antenna when mounting to the side of a
structure is not practical.The overall footprint of the frame is 29" X 35 ½" (73.66cm x 88.9cm).
Kit Contents
The kit is supplied with the following parts. If any of these items are missing, please contact Primex Wireless.
Description
5' by 1.25" (1.52m x 3.17cm) rigid galvanized conduit mast
Tripod leg: 27"(2.54cm) each in length
34 ¾"(88.26cm) Frame rail (long)
28 ¼" (71.75cm) Frame rail (short)
Long carriage bolt
Short carriage bolt
Flat washers
Locknuts
Installing the Antenna Using the Non-Penetrating Kit
Complete the steps below to mount an antenna using a non-penetrating antenna kit. The assembly is illustrated in For additional
information, see "Non-Penetrating Mount Illustration" located on page 11.
1. 1. Verify the kit contents.
2. Assemble the outer frame by laying the 2 long frame rails parallel to each, approximately 30" (76.2cm) apart.
3. Insert a short carriage bolt from the bottom at each frame rail end, pointing skyward (4 total).
4. Connect the 2 long frames rails by placing the 2 short frame rails on top of the 4 protruding bolts to form a rectangle. Make
sure the square holes in the short tail "sides" are directly opposite each other.
5. Place a washer and nut on each of the 4 bolts and finger tighten.
6. Position the tripod within the 4 sided frame.
7. Secure the 3 tripod legs to the inside of the frame by inserting 3 short bolts, from the inside and placing the washer and
nut on the outside of the frame.
8. Drop the bottom of the mast (end with hole) through the top of the tripod collar.
9. Place the remaining 2 short rails parallel to each other, separated by the bottom of the mast.
10. Align the hole at the bottom of the mast, with the 2 square holes in the short frame rail sides.
11. Insert the long bolt and connect the frame rails to the mast.
12. From the underside of the frame, insert the 4 remaining short bolts upward and connect the inner short tails to the frame.
Primex Wireless
14000 Series Transmitter - External Antenna Installation & User Guide
Mount the Antenna Mast
Qty
1
3
2
4
1
11
12
12
10