Processor Installation; Figure 4 Disengage The Socket Actuator - Quanmax QDSP-2030 User Manual

Processor Installation

Processor Handling
Carefully follow the steps below in order to prepare the CPU for installation:
1. Remove processor from packaging.
2. Handle the CPU by grasping the substrate edges only with thumb and
forefinger.
DO NOT TOUCH PROCESSOR CONTACTS TO PREVENT DAMAGING
THE CPU.
Installing the CPU
Carefully follow the steps below in order to install the CPU:
1. Check and confirm that you are installing the correct CPU type.
2. Using a screwdriver, disengage (open) the socket actuator, as shown in figure
below.
3. Align the gold triangle on the CPU with the similar marking on the socket (see
Figure below). If the processor does not drop completely into the socket, turn the
socket actuator to the open position until the processor drops completely in.
You should not have to press down on the processor. If the processor does not drop
completely into the socket, turn the actuator until the processor drops completely in.
QDSP-2030 User's Manual
CAUTION

Figure 4 Disengage the socket actuator

NOTE
20
Chapter 2