Remote Control Operation - Valor Horizon 534JLN Installation & Owner's Manual

NOTE: Before using the remote control system for
the fi rst time, the receiver and the handset must be
synchronized. See the section Remote Control Initial
Set-up on page 39 of this manual.
Current
temperature
(F or C)
Period
start or end
(Temp, Timer)
Current
programmed
period (Timer)
Display Overview
Note: In the TEMP or TIMER modes, the remote
handset senses the room temperature and adjusts the
 ame accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the  replace.
Do not leave the handset on the mantel or hearth.
TO TURN ON APPLIANCE
CAUTION
When pilot ignition is con rmed, motor turns
automatically to maximum  ame height.
•• On the valve, turn MAN knob on the ON, full
counterclockwise
•• Place ON/OFF switch (if equipped) in I (ON
position).
•• Simultaneously press the OFF and
(large  ame) buttons until a short
beep con rms the start sequence
has begun; release buttons.
•• Continuing beeps con rm the
ignition is in process.
•• Once pilot ignition is con rmed,
there is main gas  ow.
•• After main burner ignition the
handset will automatically go into
manual (MAN) control mode.

Remote Control Operation

Handset
sensor
Battery status
Current time
(12 or 24 hour clock)
Modes (Manual,
Temperature, Timer)
position.
IMPORTANT: BEFORE YOU BEGIN, please note that
on this system, the settings of time, temperature and
automatic ON/OFF can only be programmed when
the function display is fl ashing. Be patient when
programming as it can take a few seconds to set.
Set (scrolls
through
modes and
settings)
OFF (returns
to set mode,
turns the burner
and the pilot o )
Handset Overview
TO TURN OFF APPLIANCE
•• Press OFF button.
When the pilot is off, it will take 2
When the pilot is off, it will take 2
minutes before it can be lit again.
minutes before it can be lit again.
STANDBY MODE (Pilot Flame)
•• Press and hold (small  ame) to set appliance at
pilot  ame.
FLAME HEIGHT ADJUSTMENT
•• In standby mode: Press and hold
(large  ame) button to increase
 ame height.
OWNER'S
INFORMATION
Large ame
button ( ames
up, sets hours,
temperature)
Small ame
button ( ames
down and o ,
sets minutes,
temperature)
9 9