Co-Linear Venting - Valor Horizon 534JLN Installation & Owner's Manual

Dv gas fireplace heater

Hide thumbs

Table Of Contents

Table of Contents

QUALIFIED

INSTALLER

Co-Linear Vent Installations

••

The chimney and  replace opening sizes are shown in

Dimensions and Location sections of this manual.

••

Place the appliance ( tted with the co-linear adapter)

near the  replace opening but allow space for

manipulating the chimney liners on to the appliance.

••

Drop the 3-inch diameter  exible liners into the

chimney from outside.

••

Fit the liners to the co-linear adapter paying attention to

inlet and exhaust and move the appliance to its proper

position. Be aware of the minimum liner bend radius

and maximum liner horizontal run shown on page 16 of

this manual.

••

Fit the termination kit and  ashing to the exterior of the

chimney.

Secure the appliance to the  oor or wall if necessary.

Rear or Top Outlet Conversion to Co-Linear Liners using Valor

556CLA Co-Linear Adapter.

(Generic co-axial to co-linear adapter boxes may also be used as an

alternate to the 556CLA).

Only for use when retroﬁ tting a solid-fuel burning ﬁ replace and chimney.

The appliance must not be connected to a chimney  ue serving a separate solid-

fuel burning appliance.

Requires 556CLA Co-Axial to Co-Linear Appliance Adapter (or, alternatively, a

generic adapter), two lengths of 3-inch diameter  exible chimney liner, co-linear termination kit and  ashing and either

high wind vertical vent terminal cap or a low pro le vertical termination. Zero Clearance stand-offs and shields supplied

with the heater are not required for this application.

556CLA Kit

10"

7-5/8" dia.

collar

3" Inlet & Exhaust

Collars

559CLT Co-Linear Terminal