System Information Menu - IBM RS/6000 User Manual

system initialization indicators displayed on the screen, the system would enter the
Open Firmware prompt and disregards the settings in the Boot Mode Menu.
Note: After the logo screen displays, the initialization indicators display across the
v Ring Indicate Power-On Menu
Ring Indicate Power-On is an alternate method of dialing in, without establishing a
service processor session. If the system is powered off and Ring Indicate Power-On
is enabled, the server is powered on at the predetermined number of rings, If the
server is already on, no action is taken. In either case, the telephone call is not
answered. The caller receives no feedback that the server is powered on. The Ring
Indicate Power-On Menu and defaults are shown below:
1. Ring indicate power-on:
2. Number of rings:
98. Return to Previous Menu
The number of rings can be set to any number greater than zero.
v Reboot/Restart Policy Setup Menu, see "Reboot/Restart Policy Setup Menu" on
page 58.
v Power-On System
Allows immediate power-on of the system. For other power-on methods, see "System
Power-On Methods" on page 61.
v Power-Off System
Allows the user to power-off the server following a surveillance failure.

System Information Menu

This menu provides access to system configuration information, error logs, system
resources, and processor configuration.
50
User's Guide
bottom of the screen. The system initialization indicators are described in
"Open Firmware" on page 105. The user can tell also by the initialization
indicators that appear on the operator panel; watch for the code E1F1.
Ring Indicate Power-On Menu
Currently Disabled
Currently 6