Configure Ring Indicate Power On Policy; Configure Ring Indicate Power On; Configure Service Processor - IBM RS/6000 User Manual

Note: If you provide the system name, your support team can quickly identify the
You can access this service aid directly from the AIX command line by typing:
/usr/lpp/diagnostics/bin/uspchrp -m

Configure Ring Indicate Power On Policy

Note: This service aid runs on CHRP system units only.
This service aid allows the user to power-on a system by telephone from a remote
location. If the system is powered off, and Ring Indicate Power On is enabled, the
system powers on at a predetermined number of rings. If the system is already on, no
action is taken. In either case, the telephone call is not answered, and the caller
receives no feedback that the system has powered on.
Use this service aid to display and change the following settings for the Ring Indicate
Power On Policy.
Note: Some of the following settings may not be displayed by this service aid.
v Power On Via Ring Indicate (on/off)
v Number of Rings until Power On
You can access this service aid directly from the AIX command line by typing:
/usr/lpp/diagnostics/bin/uspchrp -r

Configure Ring Indicate Power On

Note: This service aid runs on RSPC system units only.
This service aid allows the user to display and change the NVRAM settings for the Ring
Indicate Power On capability of the service processor.
The settings allows the user to:
v Enable or Disable power on from Ring Indicate
v Read or Set the number of rings before power on

Configure Service Processor

Note: This service aid runs on RSPC system units only.
This service aid allows you to display and change the NVRAM settings for the service
processor.
This service aid supports the following functions:
120
User's Guide
location, configuration, and history of your system.