Icom IC-7000 Service Manual page 23

4-4 TRANSMITTER ADJUSTMENT (continue)
ADJUSTMENT ADJUSTMENT CONDITION
TX OUTPUT 1 • Connect an RF power to [ANT2]
POWER connector.
(144 MHz) • Connect an audio generator to
2
[MIC] connector and set as;
Level
3
• Transmitting
4
5
APC (VHF) 1
TX OUTPUT 1 • Connect an RF power meter to
POWER [ANT2] connector.
(430 MHz) • Connect an audio generator to
2
[MIC] connector and set as;
Level
3
• Transmitting
4
5
: 1.5 kHz/30 mV
: 1.5 kHz/30 mV
DISPLAY
Po Min(144 M) Set the output power to 1 W using [DIAL].
Then push [F-4 (SET)].
Set the output power to 12.5 W using
Po 25%(144 M)
[DIAL]. Then push [F-4 (SET)].
Po 50%(144 M) Set the output power to 25 W using
[DIAL]. Then push [F-4 (SET)].
Po 100%(144 M) Set the output power to 45 W using
[DIAL]. Then push [F-4 (SET)].
Set the output power to 50 W using
Po Max(144 M)
[DIAL]. Then push [F-4 (SET)].
APC(VHF) Push [F-4 (SET)].
Po Min(430 M) Set the output power to 1 W using [DIAL].
Then push [F-4 (SET)].
Po 25%(430 M) Set the output power to 8.75 W using
[DIAL]. Then push [F-4 (SET)].
Set the output power to 17.5 W using
Po 50%(430 M)
[DIAL]. Then push [F-4 (SET)].
Po 100%(430 M) Set the output power to 31.5 W using
[DIAL]. Then push [F-4 (SET)].
Po Max(430 M) Set the output power to 35 W using
[DIAL]. Then push [F-4 (SET)].
4 - 8
OPERATION