Checking Gas Pressure; Electrical Wiring - Majestic 20iLDVNV Installation And Operating Instructions Manual

Ildv series direct vent gas fireplace insert

Hide thumbs Also See for 20iLDVNV:

Installation and operating instructions manual (40 pages)

Installation and operating instructions manual (41 pages)

Table Of Contents

Table of Contents

20/30/40ILDV Fireplace Insert

1. Check gas type. The gas supply must be the same as

stated on the appliance's rating decal. If the gas supply

is different from the fireplace, STOP! Do not install the

appliance. Contact your dealer immediately.

2. Install and attach flex line provided with on this appliance

to 1/2" gas line.

3. After completing gas line connection, purge air from

gas line and test all gas joints from the gas meter to the

fireplace for leaks. Use a soap and water solution or a

gas sniffer.

4. To adjust flame height, turn HI/LO knob to HI to get

maximum pressure to burner. Turn HI/LO knob to LO

to get minimum pressure.

5. To check gas pressures at valve, turn captured screw

counter clockwise 2 or 3 turns and then place tubing

to pressure gauge over test point. Turn unit to high.

Figure 13. After taking pressure reading, be sure and

turn captured screw clockwise firmly to reseal. Do not

over torque. Check test points for gas leaks with a soap

and water solution or an electronic gas leak detector.

Do not use open flame to check for

gas leaks.

eLectRicAL WiRiNG

This insert will work without any electrical supply. Elec-

tricity is only needed to operate blower.

electrical connections should only be per-

formed by a qualified, licensed electrician.

Main power must be off when connecting to

main electrical power supply or performing

service. All wiring shall be in compliance

with all local, city and state codes. the ap-

pliance, when installed, must be electrically

grounded in accordance with local codes,

or in the absence of local codes, with the

National electrical code ANSi/NFPA 70 (lat-

est edition) and canadian electrical code,

cSA c22.1.

Verify proper operation after servicing.