Ftp File Operations; Making Ftp Connections - Sony PDW-1500 Operation Manual

To disable FAM connections
Execute one of the procedures described in the previous
section "Reconnecting" to make a FAM connection
between this unit and the remote computer. To disable
FAM connections, set extended menu item 215 "i.LINK
MODE" to "AV/C."
For more information about how to make this setting, see
8-3-2 "Extended Menu Operations" (page 109).

7-3 FTP File Operations

File operations between this unit and a remote computer
can be carried out by the File Transfer Protocol (called
FTP below).
Preparations
1
Connect the network connectors of this unit and a
remote computer with a network cable (see
connections illustration on page 24). Or connect this
unit to the network to which the remote computer is
connected (see connections illustration on page 25).
2
Set the IP address and other network setting items for
this unit.
For details, see "To change network settings" (page
116).
If network settings have already been made
Check the IP address of this unit.
For details, see "To check the assigned IP address"
(page 116).
3
Set the remote control switch to "NETWORK" (see
page 13).

7-3-1 Making FTP Connections

FTP connections between this unit and a remote computer
can be made with either of the following.
• The command prompt
• FTP client software
This section explains how to use the command prompt. For
more information about using FTP client software, refer to
the documentation of the FTP client software on your
system.
Note
An FTP client that supports UTF-8 is required to use
Unicode characters other than ASCII characters.
Command prompt FTP commands do not support UTF-8.
To log in
If this unit is connected to a remote computer with a FAM
connection, first exit file operations on the FAM
connection (see page 80).
1
Load a disc into this unit and put the unit into the
following state.
81
7-3 FTP File Operations