Sony PDW-1500 Operation Manual page 125

Message in time Display
data display
condition
ILL. Index! on, limit, off
FORMAT NG! on, limit, off
DI read err on, limit, off
DRV ADJ err on, limit, off
a) With respect to setting of basic menu item 016
During playback
Message in time Display
data display
condition
525/60 Disc on, limit
625/50 Disc on, limit
Disc Error! on, limit, off
a) With respect to setting of basic menu item 016
During front panel operations
Message in time Display
data display
condition
KEY INHI.! on
REMOTE! on
No Disc! on
No Disc! on, limit, off
No Disc! on, limit, off
REC INHI.! on
REC INHI.! on
Description
a)
An index file error was detected.
Automatic format failed.
A disc read error occurred.
Adjustment processing failed when a
disc was inserted.
Description
a)
An attempt was made to play back a disc
recorded with the NTSC system when
this unit is in 625 line mode (PAL
system).
An attempt was made to play back a disc
recorded with the PAL system when this
unit is in 525(U) or 525(J) line mode
(NTSC system).
Normal playback is not possible because
of a disc defect.
Description
a)
An operation button inhibited by
extended menu item 118 "KEY INHIBIT"
was pressed while the KEY INH
indicator was lit.
A button was pressed while the remote
control switch was set to "REMOTE."
A button was pressed with no disc
loaded.
An attempt to delete a clip was made
with no disc loaded.
An attempt to format a disc was made
with no disc loaded.
An attempt was made to record, display
an E-E picture, record an essence mark,
or add a quick scene selection sub clip.
An attempt was made to record, display
an E-E picture, record an essence mark,
or add a quick scene selection sub clip
while extended menu item 310 "REC
INHIBIT" was set to "on."
Action
Format the disc.
For details, see 3-5-5 "Formatting a Disc"
(page 39).
Use another disc.
Try ejecting the disc and inserting it again,
or insert another disc.
Action
Use a disc recorded with the PAL system.
Use a disc recorded with the NTSC
system.
Use another disc.
You can check the state of a disc by
checking playback condition marks (see
page 36).
Action
Set the corresponding sub-item of
extended menu item 118 to "off."
See 8-3-2 "Extended Menu Operations"
(page 109) about how to make this setting.
To operate from the front panel, wait until
control by the remote device ends and then
set the remote control switch to "LOCAL."
Operate after inserting a disc.
To perform these operations on the disc,
set the Write Inhibit tab of the disc to the
recording enabled position.
To perform these operations, set extended
menu item 310 to "off."
See 8-3-2 "Extended Menu Operations"
(page 109) about how to make this setting.
125
9-3 Alarms