Maintenance and Cleaning
Lamp Replacement
When the life of the projection lamp of this projector draws
to an end, the LAMP REPLACE indicator emits a yellow
light. If this indicator lights yellow, replace the lamp with a
new one promptly.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
CAUTION
Allow a projector to cool, for at least 45 minutes
before you open the Lamp cover. The inside of
the projector can become very hot.
Follow these steps to replace the lamp.
1
Turn off the projector and disconnect the AC power
cord. Allow the projector to cool for at least 45
minutes.
2
Remove the screw with a screwdriver, and remove
the lamp cover.
3
Remove 2 screws of the lamp with a screwdriver and
pull out the lamp by grasping the handle.
4
Replace the lamp with a new one and tighten the 2
screws back into position. Make sure that the lamp is
set properly. Replace the lamp cover and tighten the
screw.
5
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp replacement counter.
See "Lamp Replacement Counter" on the next page .
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
●
Model No. of your projector
●
Replacement Lamp Type No.
56
This indicator is yellow when
the life of the projection lamp
draws to an end.
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Lamp Cover
Lamp
Screw
: PLC-XE30
: POA-LMP93
(Service Parts No. 610 323 0719)
http://www.pureglare.com.au
Top Control
POWER WARNING LAMP REPLACE
Screw
Screw
Handle
Do not open the little compartment.
This is used to service the projector.