Sanyo PLC-XE30 Owner's Manual page 25

AUTO PC button
Press the AUTO PC button on the remote control to operate
the Auto PC function.
For more detail, see 28.
D.ZOOM buttons
Press the D.ZOOM buttons on the remote control to zoom
in and zoom out the images.
For more detail, see 34.
NO SHOW button
Press the NO SHOW button on the remote control to black
out the image. To restore to normal, press the NO SHOW
button again or press any other button. When a projected
image is captured and set as "User" in the Logo selection
(p43), the screen changes each time you press the NO
SHOW button as follows.
black out ➜ the captured image ➜ normal ➜
KEYSTONE button
For detail, see p23.
IMAGE button
Press the IMAGE button on the remote control to select a
desired image level of the screen.
For more detail, see p31, 38.
P-TIMER button
Press the P-TIMER button on the remote control. The timer
display "00 : 00" will appear on the screen and the timer
will start to count time (00 : 00 ~ 59 : 59).
To stop the P-Timer, press the P-TIMER button. Press the
P-TIMER button again, then the P-timer display will
disappear.
LAMP CONTROL button
Press the LAMP CONTROL button on the remote control to
select the lamp mode for changing the brightness of the
screen.
Normal ....normal brightness
Auto ........brightness according with the input signal
Eco ..........lower brightness reduces the lamp
power consumption and extends the
lamp life.
Remote Control
Volume +/-
buttons
(See p23)
AUTO PC
button
D.ZOOM
buttons
NO SHOW
button
✔
•
• • • • •
The message will disappear after 4 seconds.
P-Timer display
http://www.pureglare.com.au
Basic Operation
Note:
See the previous page for the other buttons.
KEYSTONE button
(See p22)
POINT ed
buttons
IMAGE button
P-TIMER button
LAMP CONTROL
button
25