Remote Control Battery Installation
Open the battery
1
compartment lid.
To insure safe operation, please observe the following precautions:
● Use (2) AA or LR6 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
● Risk of explosion if a battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Operating Range
Point the remote control toward the projector
(Infrared Remote Receiver) when pressing any
button. Maximum operating range for the
remote control is about 16.4' (5m) and 60° in
front of the projector.
Install new batteries into
2
the compartment.
Two AA size batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with
compartment.
16.4'
(5 m)
http://www.pureglare.com.au
Part Names and Functions
Replace the
3
compartment lid.
pins
in
the
30°
30°
13