Installing The Light Kit - HAMPTON BAY Parker Ridge Owner's Manual

Installing the Mounting
Plate
1. Remove 1 of 3 screws from the mounting ring
and loosen the other 2 screws. (Do not remove)
2. Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 13)
Mounting Plate
8

Installing the Light Kit

CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
1. Loosen the 3 screws from the mounting plate.
(Do not remove)
2.
Raise and hold the light plate close to the
mounting plate and proceed to do the wire
connections.
connectors from the light plate and fan, follow
the same procedure with the black wire
connectors. (Fig. 14)
3. Place the key holes on the light plate over the 3
screws previously loosened from the mounting
plate, turn light plate until it locks in place at
the narrow section of the key holes. Secure by
tightening the 3 screws previously loosened.
(Fig. 14)
Mounting Ring
4. Install 100W halogen bulb (included). (Fig.
15).
5. Raise light kit up against bottom of fan housing
Screws
and secure it to fan by twisting glass clockwise
until snug. DO NOT OVERTIGHTEN. (Fig.
Figure 13
15)
Connect the white wire
Wire Connection
Plugs
Light Plate
Bulbs
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
Mounting
Plate
Screws
Figure 14
Mounting Plate
Glass
Shade
Figure 15