iSolution Lighting Equipment User Manual page 6

Slave Mode
Press the MENU button until the
and the display will blink. Use DOWN and UP button to select the
(2 light show) mode. Once the mode has been selected, press the ENTER button to
setup or automatically return to the main functions without any change after 8 seconds. To go
back to the functions without any change press the MENU button again.
Blackout Mode
Press the MENU button until the
and the display will blink. Use DOWN and UP button to select the
(no blackout) mode. Once the mode has been selected, press the ENTER button to
setup or automatically return to the main functions without any change after 8 seconds. To go
back to the functions without any change press the MENU button again.
Pan Inversion
Press the MENU button until the
and the display will blink. Use DOWN and UP button to select the
(pan inversion) mode. Once the mode has been selected, press the ENTER button
to setup or automatically return to the main functions without any change after 8 seconds. To
go back to the functions without any change press the MENU button again.
Tilt Inversion
Press the MENU button until the
and the display will blink. Use DOWN and UP button to select the
(tilt inversion) mode. Once the mode has been selected, press the ENTER button to
setup or automatically return to the main functions without any change after 8 seconds. To go
back to the functions without any change press the MENU button again.
Led Display
Press the MENU button until the
and the display will blink. Use DOWN and UP button to select the
(Led off) mode. Once the mode has been selected, press the ENTER button to
setup or automatically return to the main functions without any change after 8 seconds. To go
back to the functions without any change press the MENU button again.
is shown on the display. Pressing ENTER button
(normal) or
is shown on the display. Pressing ENTER button
(yes blackout) or
is shown on the display. Pressing ENTER button
is shown on the display. Pressing ENTER button
is showing on the display. Pressing ENTER button
(Led on) or
10A
Display Inversion
It is good for you to install the unit on the floor or under ceiling. Press the MENU button until
the is blinking on the display. Use the ENTER button to change to the mode
(display inversion), It will automatically store after 8 seconds. Or press the ENTER
button again return to the mode
the MENU button.
Display normal mode for the fixture putting on the floor.
Display inversion mode for the fixture fixing under ceiling.
Press the MENU button until the
and the display will blink. Use DOWN and UP button to select the (0~255) value. Once the
value has been selected, press the ENTER button to setup or automatically return to the
main functions without any change after 8 seconds. TO go back to the functions without any
(normal) or
change press the MENU button again.
Self-Test
Press the MENU button until the
and the unit will run self-test by built-in program. To go back to the functions press the MENU
button again.
(normal) or
Ambient temperature of lamp
Press the MENU button until the
and the ambient temperature of lamp will show on the display. To go back to the functions
press the MENU button again.
Press the MENU button until the
and the display will show the number of working hours of the unit. To go back to the functions
press the MENU button again.
(display normal). To go back to the functions press
Focus Adjust
is blinking on the display. Pressing ENTER button
is blinking on the display. Pressing ENTER button
is blinking on the display. Pressing ENTER button
Fixture Hours
is blinking on the display. Pressing ENTER button
11A