Reset To Factory Default Settings; Fault Reset - Sena SPH10H User Manual

Bluetoth stereo headset and intercom for half helmet

Hide thumbs Also See for SPH10H:

Table of Contents

21. RESET TO FACTORY DEFAULT

SETTINGS

1. To restore the SPH10H to factory default settings,

press and hold the Phone Button for 12 seconds

until the LED shows solid red and you hear double

beeps. You will hear a voice prompt saying "Factory

reset".

2. Within 5 seconds, press the Jog Dial to confirm

reset. The headset will be restored to factory

setting and switched off automatically. You will hear

a voice prompt saying "Headset reset, good-bye".

3. If you don't press the Jog Dial within 5 seconds,

the reset attempt is canceled and the headset

returns to stand-by mode. You will hear a voice

prompt saying "Canceled".

When the SPH10H is not working properly or is in a

faulty status for any reason, you may reset the system

by pushing the pin-hole reset button on the back of the

left headset main unit.

1. Unzip the left SPH10H headset to open.

SPH10H

Table of Contents