Table of Contents
Advertisement
SAFEStor User Guide
Chapter 4 – Configuration Using Web Module
The RAID Controller of the Storage Enclosure can be configured and managed using the Web
based RAID management software. This chapter describes how to use the Web based
software. For information on accessing the Web based RAID Management Software refer to
Chapter 3.
NOTE: The following screens are taken from the SCSI product, the Fibre Channel
version will differ slightly (mainly in the area of channel configuration).
Initial C on fig uration
When you log into RAID Manager for the first time (user name = admin, password = 0000)
the overall display screen is shown:
There are six main functions in the RAID Management software:
Quick Functions – allows you to quickly build a RAID system with minimal user input
•
required.
RAID Set Functions – allows you to create, delete, modify and expand a RAID set as well
•
as create and delete hot spare drives and rebuild RAID sets.
Volume Set Functions – allows you to create, delete, modify and check volume sets.
•
Physical Drives – allows you to create, modify and delete pass through drives as well as
•
identify physical drive locations in the enclosure.
System Controls – allows you to configure system functions such as alarms,
•
notifications and passwords, as well as upgrading controller firmware and restarting the
controller.
Information – allows you to view RAID set, hardware and system wide information.
•
Q uick F un ctions
This function allows you to create a RAID Volume set with minimal input. When you click
on the Quick Create link in the navigation panel the
information panel.
screen is displayed in the
Q uic k C r e a te
Page 16
Advertisement
Table of Contents
