Alert By Mail Configuration - Xerox SAFEStor User Manual

SAFEStor User Guide
2. The following parameters can be set from this screen:
DHCP Function
Local IP Address
Gateway IP Address
Subnet Mask
HTTP Port Number
Telnet Port Number
Current IP Address
Current Gateway IP
Address
Current Subnet Mask
EtherNet MAC
Address
3.
Once the parameters above have been set, check the Confirm The Operation
check box and then click Submit.

Alert By Mail Configuration

This function allows you to configure the system to send an email to specified email addresses
when an event occurs. To configure the Alert By Mail function, follow the procedure below:
1. From the navigation panel, select Alert By Mail Config. The email alert parameters are
displayed in the information panel.
Select whether you want to enable or disable
DHCP functionality on the enclosure using
the drop down list.
Enter the local IP address in the boxes (if
DHCP is disabled)
Enter the Gateway IP address in the boxes
Enter the Subnet Mask address in the boxes
Enter the HTTP Port Number in the box.
Enter the Telnet Port Number in the box.
Displays the current IP address.
Displays the current Gateway IP address.
Displays the current Subnet Mask.
Displays the MAC address of the unit.
Page 32