System Menu; Table 4 – Factory Default Settings For Kdc200 - KoamTac KDC200 User Manual

System Menu

Memory Status: Checks the number of stored barcodes and memory usage.
Reset Memory: Resets KDC memory by erasing all stored barcodes, application and BT registry.
Auto Erase: Erases all stored barcodes upon reaching buffer full condition if Enabled is selected
Sleep Timeout: Sets amount of time KDC waits, when not being used, before going to sleep.
Date/Time: Sets the date and time of KDC which can also be set using KTSync
Battery: Shows current status of battery power level.
Version: Shows KDC firmware version and serial number.
Button Lock: Locks or unlocks KDC scan and scroll buttons.
Beep Sound: Enables or disables KDC beep sound.
Auto Exit: Enables KDC to automatically exit KDC Menus.
Port Status: Enable or disable KDC port messages.
Display Format: Selection of display format - Time & Battery, Type & Time, Type & Battery, or
Memory Status
Scrolling : Enables or disables display scrolling for a barcode with more than 40 characters
Factory Default: Resets certain KDC options to factory defaults. Factory defaults for all KDC models
are listed below.
KDC Mode
Normal
Set Barcodes
EAN13
EAN8
UPCAUPCE
CODE39
ITIF14
CODE128
I2of5
CODABAR
GS1-128
CODE93
CODE35
Code Options
UPCEreturnCheckDigit
UPCAreturnCheckDigit
EAN8returnCheckDigit
EAN13returnCheckDigit
Table 4 – Factory Default Settings for KDC200
Scan Options
Scan Angle – Wide
Filter – Normal
Timeout – 2 seconds
Minimum Length – 4 Characters
Security Level – 1 Level
Partial Disp - Start 1, Length 0
Data Process
Wedge/Store – Wedge & Store
Always
Data Format – Barcode Only
Handshake- Disabled
Terminator - <CR> + <LF>
Data Editor
AIM ID – None
Partial Data – Start 1, Length 0
PDF417-KDC200P
Quality Level - 2
Tilt Level - 3
Start/Stop – Disable
33
KDC200 User Manual
®
Bluetooth
-KDC200-KDC200P-
KDC300
Power – Disabled
Auto Connect – Disabled
Auto Power On –Disabled
Auto Power Off- Enabled
Beep Warning – Enabled
Power Off Time – 5 minutes
PowerOff Msg – Enabled
Wakeup Nulls - Enabled
System
Sleep Timeout – 5 seconds
Button Lock – Disabled
Beep Sound – Enabled
Auto Exit –Enabled
Port Status –Enabled
Display Format – Time & Battery
Scrolling – Enabled