Replacing The Drum Light Bulb; Replacing The Drum Light Housing; Replacing The Drum Light Socket; Replacing The Felt Seals - GE DSXH47EG Technical Service Manual

Replacing the drum light bulb:

1. Open the dryer door, release the clip holding the
light shield by pushing up, and unscrew the bulb.

Replacing the drum light housing:

1. Disconnect the dryer from electrical supply.
2. Remove the top, lean the top of the front panel
forward and disconnect the wires from the light
socket.
3. Push in to release the tab at the end of the housing
and push the housing into the drum.

Replacing the drum light socket:

1. Disconnect the dryer from electrical supply.
2. Remove the top and disconnect the wires from the
light socket.
3. Remove the light bulb, squeeze the tabs on the
side of the socket and push the socket into the
housing.

Replacing the felt seals:

1. Disconnect the dryer from electrical supply.
2. Remove the front panel.
3. The felt seals are 2 pieces that are glued to the
front panel rim that the drum rides on.
4. To replace a seal, pull the old seal off and glue the
replacement to the rim.
37