Removing The Burner (Gas Dryers); Removing The Ignitor (Gas Dryers); Removing The Gas Valve Assembly (Gas Dryers) - GE DSXH47EG Technical Service Manual

2. Unplug the harness from the motor and remove the
idler assembly.
3. Unscrew the blower wheel from motor shaft.
4. Release the front motor lock from the blower
housing.
5. Release the spring hold down on the rear of the
motor and lift the motor out.
Spring
Hold
Down
Removing the burner (Gas dryer):
1. Disconnect the dryer from electrical supply and
remove the front panel.
2. Unplug the igniter, remove the (2) screws holding
the burner to the valve assembly bracket, and slide
the burner into the combustion chamber to release
burner from the valve.

Removing the ignitor (Gas dryers):

1. Disconnect the dryer from electrical supply and
unplug the igniter harness.
2. The igniter is held to the burner mounting bracket
by a screw and a tab. Remove the screw and
lift the igniter up to release the tab, then slide
the igniter forward.
Removing the gas valve assembly
(Gas dryers):
1. Turn the gas supply off and disconnect the dryer
from electrical supply.
2. Unplug the wires from the valves.
43