Removing The Idler Pulley; Removing The Idler Pulley Assembly; Removing The Drive Motor - GE DSXH47EG Technical Service Manual

4. Remove (2) screws holding the housing to the dryer
base.
5. Remove the front motor lock by inserting a screw-
driver at the rear of the housing to release the
housing from the motor.
6. Raise the front of the motor and pull the housing
forward.

Removing the idler pulley:

1. Disconnect the dryer from electrical supply and
remove the rear access panel.
2. Release the belt from the motor pulley, remove
the "C" clip from the shaft and slide the idler
pulley off.
CLIP

Removing the idler pulley assembly:

1. Disconnect the dryer from electrical supply and
remove the rear access panel.
2. Release the belt from the motor pulley.
3. Release the idler spring from the motor and lift
the assembly off the motor.

Removing the drive motor:

1. Disconnect the dryer from electrical supply and
remove the drum.
42