2. Separate the panels on the hinge and slide the inner
panel out from behind the flange of the outer panel.
Removing the door handle:
1. Separate the panel and lift the handle off the
inner door liner.
Removing the upper or lower door strike:
1. Separate the panel, squeeze the ends of the
strike and push it through the inner panel.
Removing the door seal:
1. The door seal is fastened to the inner door liner by
expandable tabs pushed through slots in the liner.
2. If the seal is to be replaced, open the door and pull
the seal from the liner. If the seal is to be reused,
separate the panels and use a small screwdriver to
push the tabs through the liner.
Removing the front access panel:
1. Place a 2x4 under the front of the dryer and
remove the two screws holding the panel to the dryer
base.
34