Door Switch; Drum; Drum Light; Drum Rollers - GE DPGT750EC/GC Technical Service Manual

Drum Rollers

The 304 stainless steel drum rotates on four drum
rollers. Two on the front drum support and two on
the rear drum support.
The drum roller comes as a complete assembly.
To remove the drum rollers:
1. Remove the
Top Cover
2. Remove the front drum support to access the
front drum rollers. Remove the
access the rear drum rollers.
3. Each drum roller is held in place by a plastic
triangular clip.
4. Remove the plastic triangular clip with a small
flat-blade screwdriver and remove the drum
roller.
5. To remove the drum roller shaft from the front
drum support, remove the 14 mm hex nut that
holds the shaft in place.
6. To remove the drum roller shaft from the rear
drum support:
a. Remove the Heater Assembly.
b. Remove the seven screws from the back
of the dryer that hold the rear drum
support in place.
c. Remove the 14 mm hex nut that holds the
drum roller shaft in place.
and .

Front Panel

to

Drum

– 25 –

Door Switch

The door switch is fastened to the front panel by
two locking tabs and is common to all dryer
functions.
• When the dryer door is closed, the switch will
complete the motor circuit, allowing dryer
operation.
• Immediately upon detection of a door opening,
the drum motor and blower motor shut off and
all heat is disabled.
• If the door is open at the start of a cycle or
while a cycle is running, the SUMMARY
SCREEN is displayed on the LCD screen.
• Once the door is closed, the dryer pauses and
the SUMMARY SCREEN is displayed showing
cycle parameters and the current estimated
cycle time remaining.
• The dry cycle can be resumed by pressing the
START/STOP pad.
• Opening the dryer door closes the drum light
circuit, allowing the drum light to be energized.
• The door switch circuit can be checked in the

factory test mode.